Planar Dome EX manual Prompting user response during

-s	Silent mode. Use a response file instead
	of prompting user response during
	installation.
-f1<path\response file>	Use the response file specified during
	installation. If no -f1 switch is given, the
	installation uses the response file in the
	same directory in which setup.exe
	resides.
-f2<path\log file>	Save any output to the log file specified
	during installation. If no -f2 switch is
	given, the installation saves to the log
	file in the same directory in which the
	response file resides. This may cause
	a problem if setup is run from the CD-
	ROM drive.
-remove	Run uninstallation.
-bit8	Set all Dome CX or Dome EX displays to
	8-bit mode (default).
-bit32	Set all Dome CX or Dome EX displays to
	32-bit mode. Grayscale switches are
	ignored when this switch is specified.
-static	Set 8-bit mode to static gray palette
	(default).
-notstatic	Set 8-bit mode to dynamic gray palette.
-yesddraw	Enable DirectDraw (default).
-noddraw	Disable DirectDraw.
-autodetect	Enable AutoOrientation for Dome EX
	displays (default).
-noautodetect	Set all displays to portrait orientation.

34 Dome EX Display