Installing the Display

Before you install the Dome DX2 or the AX3 display controller, remove any existing graphics card and its driver from your system. Also disable any onboard graphics capability on the motherboard. If you are installing the Dome DX2 board, you must set the DIP switches for your system configuration. See “Set the DIP Switch on the Dome DX2 Board” on page 7.

Dome Display

Dome DX2 Controller

AX3 Controller

 

 

 

E2

9

 

 

 

 

E3

9

9

 

 

 

E3c

9

9

 

 

 

E5

9

 

 

 

 

Warning

In locations where 240V outlets are used, connect the Dome EX display only to a center-tapped, 240V, single-phase supply (only for Canada and the United States).

If you leave the computer turned on, you could get an electric shock and cause damage to the system components.

Remove the display controller slowly from its package and static- shielding bag to prevent an electrostatic discharge.

Static electricity can damage the controller. When touching the board or parts of the motherboard, take these precautions:

Wear an antistatic wrist strap.

Discharge your body’s static electricity repeatedly by touching the power supply or the metal surface of the computer chassis.

6 Dome EX Display

Page 16
Image 16
Planar Dome EX manual Installing the Display