97707987 Rev A 31
6Click on the Ports tab. The SNAZ’s network (Ethernet) ports
are listed:
The following information is also displayed:
•Name - The Ethernet port name. The SNAZ has two
Ethernet ports eth0 and eth1. Clicking on the port Name
allows you to view the network ports configuration.
•Enabled - Shows whether the Ethernet port is enabled.
•DHCP - Shows whether the DHCP is enabled.
•IP Address - Shows the IP address of the port
•Netmask - Shows the Network mask of the port
•Link up - Whether the two ports are linked
•Bond - Whether or not the ports are bonded. This is used
to provide load balancing (where the two ethernet cards
share network activity to prevent overloading) or fault
tolerance (where one ethernet card is used, the other
being kept as a backup in case of failure of the first).
7Click on the Hosts tab.
8Click to add a host. This page allows you to enter a
list of Hosts which are known to the SNAZ. This list is used to
resolve hosts when DNS is not available.
9Click to save the changes.