Polycom RS-232 manual Ahcp -- Enable or Disable Call Progress Based Auto Hangup

This command is saved to non-volatile memory only as part of a preset. The state of this command will be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.

Example Description

Set AGC ramp rate on input channel S01AGCRATE13 1 to 3 dB/sec.

Query the AGC ramp rate on input S01AGCRATET? channel T .

Status Message

S01AGCRATE13

S01AGCRATETx where x is a number between 1 and 5, depending on the current setting of the AGC ramp rate on input channel T .

8.9.AHCP -- Enable or Disable Call Progress Based Auto Hangup

This command sets or queries the status of the call progress based auto hangup feature. There are two methods of auto hangup supported: call progress and loop drop. The call progress method listens for off-hook or busy tones and hangs up the phone if they are detected. The loop drop method looks for a drop in loop current on the phone line and hangs up the phone if a loop current drop is detected. The AHCP command controls the call progress auto hangup feature. The AHLD command controls the

loop drop auto hangup feature. These two features are controlled and implemented independently.

This command is a boolean command. See Section 6.1 for more information on this type of command.

This command is saved to non-volatile memory only as part of a preset. The state of this command will be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.

Example	Description	Status Message
S01AHCP1	Enable call progress based auto hangup mode.	S01AHCP1

S01AHCP0Disable call progress based auto hangup mode.S01AHCP0

S01AHCPx , where x is 0 or 1

S01AHCP2 Toggle call progress based auto hangup mode. depending on the current state of the

	call progress based auto hangup mode.
S01AHCP? Query auto hangup mode.	S01AHCPx , where x is 0 or 1
	depending on the current state of the
	call progress based auto hangup mode.

8.10.AHLD -- Enable or Disable Loop Drop Based Auto Hangup

This command sets or queries the status of the loop drop based auto hangup feature. There are two methods of auto hangup supported: call progress and loop drop. The call progress method listens for