Polycom manual Flash -- Execute Hook Flash, Flow -- Set Flow Control Mode for RS-232 Port

S01FADERIA?	Query the fader gain on input
	A.
S01FADERI*6	Set fader gain on all inputs (1,
	A, B, T) to 6 dB.

Set fader gain on input channels A and B to 0 dB and

S01FADERI*ìääì gain on input channels 1 and T to 9 dB.

S01FADERI*?	Query fader gain on all inputs
	(1, A, B, T) .

S01FADERIAx , where x is a number between 0 and 30, depending on the current setting of the fader gain on input channel A.

S01FADERI*èèèè

S01FADERI*ìääì

S01FADERI*abcd, where a-d are each

between ä and ÿ, depending on the current setting of the fader gains for each of the four input channels.

8.49. FLASH -- Execute Hook Flash

This command puts the phone on-hook and then takes it back off-hook after a delay. The amount of time between on-hook and off-hook is controlled by the COUNTRY setting and has be set for each

country to meet each country's specific compliance requirements. If the phone is on-hook when this command is given, then no action is performed.

Example Description Status Message

If the phone is on-hook, no action is performed, and the response will be

S01FLASH

If the phone is off-hook, the response will be S01FLASH Execute hook flash. S01FLASH

S01PHONE0

S01PHONE1

The PHONE status messagges occur when the phone goes on-hook and back off-hook.

8.50. FLOW -- Set Flow Control Mode for RS-232 Port

This command sets the flow control mode for the rear panel RS-232 port. The valid settings are:

Command Value	Description
0	No flow control.
1	Hardware flow control.
2	Auto-detect hardware flow control or no flow control.