Polycom RS-232 manual Amoffat -- Set Off Attenuation for the Specified Automixer

S01AMNOMAT11

S01AMNOMATA0

S01AMNOMATT2

Enable NOM attenuation on output 1 .

Disable NOM attenuation on output A.

Toggle NOM attenuation status on output T (telephone output) .

S01AMNOMAT11

S01AMNOMATA0

S01AMNOMATTx , where x is either 0 or 1 depending on the current mute status of NOM attenuation on the ouptut.

S01AMNOMATB?	Query NOM attenuation status
	of output B.
S01AMNOMAT*1	Enable NOM attenuation on all
	outputs (1, A, B, T) .
S01AMNOMAT*0	Disable NOM attenuation on
	all outputs (1, A, B, T) .

Enable NOM attenuation on outputs 1 and A, and disable

S01AMNOMAT*1100 NOM attenuation on outputs B and T.

S01AMNOMAT*2	Toggle status of NOM
	attenuation on all outputs.

S01AMNOMAT*?	Query NOM attenuation status
	of all outputs.

S01AMNOMATBx , where x is either 0 or 1 depending on the current NOM attenuation status of the output.

S01AMNOMAT*1111

S01AMNOMAT*0000

S01AMNOMAT*1100

S01AMNOMAT*abcd , where each of the letters (a, b, etc.) is either 0 or 1 depending of the current status of NOM attenuation on the corresponding output. If this command was sent after the example above, then the status message would be S01AMNOMAT*0011 .

S01AMNOMAT*abcd , where each of the letters (a, b, etc.) is either 0 or 1 depending of the current status of the NOM attenuation on the corresponding output. If this command was sent after the example above, then the status message would be S01AMNOMAT*0011 .

8.26.AMOFFAT -- Set Off Attenuation for the Specified Automixer

This command sets the off attenuation (in dB) for the specified automixer. Setting this value to 18 would result in the microphone signals being attenuated by 18 dB when gated off. This value is set independently for each of the automixers. The first argument of this command specifies the automixer number (1-2) to adjust. The second argument specifies the off attenuation.

Even though this is a channel integer command, use of the wildcard for specifying the automixer number is not supported.

This command is a channel integer command. See Section 6.3 and Section 6.2 for more information

on this type of command. The minimum and maximum values for this command are 1 and 100, respectively.