Chapter 4 | Operation |
This section describes:
STurning the UPS on and off
SStarting the UPS on battery
SInitiating the battery test
STransferring the UPS to Bypass mode
SOperating modes
Turning the UPS On
After the UPS is connected to utility power, it enters Standby mode.
To turn on the UPS, press the On button on the front panel (shown in Figure 14 on page 31). The μindicator illuminates solid and the bar graph indicators display the percentage of load being applied to the UPS.
Starting the UPS on Battery
NOTE Before using this feature, the UPS must have been powered by utility power at least once.
To turn on the UPS without using utility power, press and hold the
On button for approximately three seconds. The UPS supplies power to your equipment and goes into Battery mode.
EATON Powerware® 9125 | 29 |
www.powerware.com |
|