Powerware 6000 VA, 5000 manual Communication, USB Port

Chapter 6 Communication

The Powerware 9125 UPS is equipped with a USB port, a DB-9 communication port, and an X-Slot communication bay (see Figure 18).

Either the USB port or the DB-9 communication port may be used to monitor the UPS; however, they cannot operate simultaneously.

The X-Slot communication bay can accommodate any Powerware X-Slot card and can operate simultaneously with the USB port or DB-9 communication port.

X-Slot Communication Bay

USB Port

DB-9 Communication Port

Figure 18. Communication Options

USB Port

The UPS can communicate with a USB-compliant computer using

Powerware LanSafet Power Management Software (v5.0.1 or higher).

To establish communication between the UPS and a computer:

1.Connect the USB cable to the USB port on the UPS rear panel (see Figure 18).

Connect the other end of the USB cable to the USB port on your computer.

2.Install the Powerware LanSafe software and USB drivers according to the instructions provided with the Software Suite CD.

EATON Powerware® 9125 Two-in-One UPS (5000/6000 VA) User’s Guide S 164201513 Rev B	37
www.powerware.com