Powerware 6000 VA, 5000 manual Chapter Configuration

Chapter 5 Configuration

When the UPS is in Configuration mode, the bar graph indicators represent the configuration options. Use the control buttons

(On button and button) to modify the UPS configuration. Figure 17 shows the LEDs and Table 2 explains the corresponding options.

NOTE The UPS can be configured while in Battery mode.

C A U T I O N

DO NOT press the Off button while the UPS is in Configuration mode; pressing the

Off button removes all power to your equipment immediately and the UPS enters

Standby mode.

To reconfigure the UPS default settings:

1. Press and hold the On button and the button simultaneously

for three seconds. The UPS switches to Configuration mode.

The bar graph indicators flash briefly and then display the enabled options.

2. Press and hold the On button until you hear the second beep to scroll through the options. The LED for the selected option indicates the current setting; flashing represents disabled options (see Figure 17 and Table 2).

Scrolling past the last LED returns to the first configuration option.

If you press the On button and nothing happens, the UPS is still in Operation mode. Repeat Step 1 to enter Configuration mode, and then perform Step 2.

3.Press the button ONCE to select the Voltage option or to toggle the Site Wiring Fault Alarm on or off.

NOTE The UPS exits Configuration mode automatically after two minutes of inactivity.

4. Press and hold the On button and the	button simultaneously
for three seconds to exit Configuration mode at any time.
EATON Powerware® 9125 Two-in-One UPS (5000/6000 VA) User’s Guide S 164201513 Rev B		35
	www.powerware.com