Precor 300753-201 manual Completing the Console Installation, To complete the installation

30 Assembling and Maintaining the EFX 821 Elliptical Fitness Crosstrainer

Completing the Console Installation

Before you complete the final installation steps, double-check the connections you have made. Make sure that all cables are fully and securely connected, and that any unneeded cables are tied back properly.

Note: During these steps, you will need the four ³ -inch flat-head screws that were packed with the console.

To complete the installation:

1.Tilt the control console backward (toward yourself) until the tab on the top edge of its back plate slides along the top edge of the console mount and the screw holes align properly.

2.Insert the four ³ -inch flat head screws through the holes in the console mount and thread them into the holes in the back plate on the console. Tighten the screws fully using a ⁵ -inch hex wrench.

3.Line up the two small tabs at the bottom of the console’s back cover with the slots at the bottom of the console case. Insert the tabs into the slots.

4.Insert the two #8–32 x ¹ " #2 Phillips-head screws that you removed earlier into the holes at the top edge of the console’s back cover. Tighten the screws fully.

5.If necessary, reinstall any body panels you have removed from the base unit.