Changing Treadmill Settings

Through a specific set of number key presses, you can customize the pause or cool down times and adjust the maximum limit for the running belt speed.

To access the menu and change the settings, perform the following steps:

1.At the banner, press the following keys in sequence without pausing between selections:

PAUSE/RESET, 5, 6, 7, 1

Numbers appear on the display as you press the associated key.

DIAGS - SET PARAMETERS scrolls across the display followed by SAFETY CODE.

Selecting Safety Code Protection

When the treadmill is shipped from the factory, the safety code protection feature is disabled. If you enable the safety code, the display prompts you to enter the safety code at the beginning of your exercise session. The running belt will not move unless the proper 4-digit safety code is entered.

If the correct code: 1, 2, 3, 4, is not entered within 30 seconds, further access is denied. Refer to Entering the Safety Code.

2.At the SAFETY CODE prompt, press OK. Use a navigational arrow key to alternate between the two selections.

Setting

Description

 

 

ENABLED

Causes the safety code prompt to appear

 

prior to a workout and when returning

 

from pause mode.

 

 

DISABLED

Does not require a safety code to operate.

 

 

CAUTION: Do not assume the treadmill is safe because of safety code protection. Never leave children unsupervised around the treadmill.

3.When you are ready, press OK to accept the display setting and move to the next program. Or, press PAUSE/ RESET to return to the banner.

Owner’s Manual: Advanced Programming and Troubleshooting

50

Page 52
Image 52
Precor 9.33, 9.31 manual Changing Treadmill Settings, Selecting Safety Code Protection