Setting Up the Console | 23 |
Remote Speed Control (Treadmill only)
Value: Enable or Disable
(Default: Disable)
When this feature is enabled, the CSAFE SetSpeed command and the CSAFE SetGrade command are available if:
The treadmill is in the CSAFE "InUse" state.
The speed or grade values sent are within range.
Set Auto Stop (Treadmill only)
Value: On or Off
(Default: On)
Set to On to bring the treadmill to a gradual stop when no user is on the equipment. This can occur if a user steps off the equipment during a workout and does not turn it off.
Set Crossramp Auto-level (EFX only)
Value Range: 0 to 20
(Default: 10)
Use this setting to choose a specific ramp incline so that the EFX automatically returns to that incline at the end of a workout session.
Set Resistance Range (Bike only)
Value Range: High, Medium, or Low
(Default: High)
You can set a low, medium, or high base resistance on the recumbent or upright bikes. There are 25 levels of resistance within each base setting, but the base setting affects the overall resistance range. The following ranges are available:
High: Provides full resistance range.
Medium: Provides approximately two thirds of the resistance that is available within the high group setting.
Low: Provides approximately one third of the resistance that is available within the high group setting.
