Precor P10 manual Event Description of Event Number

Setting Up the Console		27
	Event	Description of Event
	Number
	31	Incorrect Communications event upper board to lower
		board
	32	Communication event upper board to lower board
	33	Incorrect communications event lower board to upper
		board
	37	E-STOP error (treadmill only)
	40	Lift motion detected
	42	Lift position value out of range
	43	Zero switch not found
	44	Un-commanded lift motion
	45	Lift going in the wrong direction
	50	Too much brake (magnet) current
	53	Cannot read target, cannot find home switch
	54	Target pulses lost during operation
	55	Brake home switch activated unexpectedly
	60	Auto Stop sensor failure (treadmill only)
	61	Auto Stop not present (treadmill only)
	62	Vertical sensor failure (AMT only)
	70	Belt replacement, lower control board not read (AMT
		only)
	71	Belt replacement, new lower control board (AMT only)
	72	Belt replacement, lower control board version unknown
		(AMT only)
	73	Belt replacement, lower control board record bad (AMT
		only)
	74	Belt replacement, lower control board refurbished
		console (AMT only)
	75	Belt replacement, refurbished lower control board
		(AMT only)
	76	Belt replacement, console stride count is less than lower
		control board (AMT only)
	77	Belt replacement, console stride count is greater than
		lower control board (AMT only)
	78	Belt replacement warning (AMT only)
	79	Belt replacement required (AMT only)