TOC | INDEX |
Circular Labels
If you are using Circular Labels you must adjust the Stock sensor to correspond with the very top of the label where the circles are closest together. If the sensor is too far to the right or the left the printer will still sense the label but the image may be offset downward because the printer will start printing at the wrong position. If you are using stock that has multiple labels across make sure the sensor corresponds to a place on the stock that has a label and not a vertical gap.
Through Hole Labels
If you are using card stock or label stock that has a hole punch or a notch to identify a transition from backing to label, you can adjust the Sensor Bar to position it over the identifying mark.
The Sensor Bar has a guide in inches and milimeters that will help you identify where to set the bar to align the sensor over any identifying mark or top of a circular shape. To do this, measure the distance from the edge of the label stock to
the correct position on the stock. Set the sensor bar to this measurement. For example, if you have a two inch circular
1 1/8 inches. Set the Sensor Bar to this value.
1/2”
Center
of Hole
1 1/8”
Center
of Circle
Circular Labels |
Hardware and Software Settings 11
