➊Paper is ejected also by FF or the limit, fixed by the form length or the bottom margin.
➋This sequence selects manual cut sheet paper process.
➌This sequence selects fanfold paper process for tractor 1.
➍This sequence selects fanfold paper process for optional tractor 2. If an optional tractor 2 is installed, sequences for selecting the automatic single sheet feeder (ASF) are ignored.
➎Selection of bin 1 or 2.
Vertical alignment of the first printable line in steps of n1⁄72 inch downwards is optional. n is set to 12⁄72 inch (one line at 6 lpi) in the default menu.
➏ Depending on the hardware, up to 9 bins can be selected.
∧
(bin 1 - 9 = CSI 21 - CSI 29).
➐Depending on the hardware and in the case a sorter has been installed, up to 19 exit
ports can be selected.
∧
(stacker 1 - 19 = CSI 31 - CSI 49).
➑The page is set from view or
This means, that the print head moves to the current position or to the first possible line of the following document.
➒Independent of the menu settings the paper is set to
This sequence has no affect, if the respective position is just set manual (by means of the “Tear” key) or automatically (printer menu setting: Parameter group “Auto Tear”). **)
➓Independent of the menu settings the paper is set to view position (last printed line). This sequence has no affect, if the respective position is just set manual (by means of the “Tear” key) or automatically (printer menu setting: Parameter group “Auto Tear”).
➀This sequence is only available if an optional cutter is installed and cuts fanfold paper at the next perforation.*)
➁This sequence is only available if an optional cutter is installed; it cuts above the current line, if the text to be printed was ended with a CR (hex. 0D, dec. 13), it cuts below the line, if the text to be printed was ended with a LF (hex. 0A, dec. 10).
The sheet feeder - if installed and connected - has to be selected via the menu of the printer (refer to the Operator’s Manual).
*) | If a cutting device is installed. |
**) | If no cutting device is installed. |