Perforation Skip
Reset Perforation Skip
ESC N ESC O
Data Structure ASCII | ESC "N" | <n> | set space before perforation (perforation skip) | ➊ | |
hex. | 1B | 4E | <n> |
|
|
dec. | 27 | 78 | <n> |
|
|
ASCII | ESC | "O" |
| reset perforation skip | ➋ |
hex. | 1B | 4F |
|
|
|
dec. | 27 | 79 |
|
|
|
Description ➊ This code sequence enables the perforation skip function and sets the bottom margin (distance between the last print line of one page and the first print line of the following page) to n lines. The value specified for n must be in the range of 1 to 127 and must be smaller than the form length minus the top margin.
The printer automatically advances the paper to the first printable line of the next page whenever the current print line falls within the margin area defined as n lines from the bottom of the current page (n being the value specified for the bottom margin area).
The margin area before and after the perforation is n times the current line spacing. Once this margin area has been defined, it will not be affected by changing the line spacing and remains effective until the printer receives code sequence ESC O (reset perforation skip), or until form length is changed by ESC C or ESC C 0.
➋This code sequence deselects the perforation skip function set by ESC N <n>.The bot- tom margin is set to 0 lines, thus disabling perforation skip. This results in continuous printout, unless the software used in the computer defines the form length by counting the printed lines.
This function only applies for fanfold paper, not for cut sheet processing or with mounted sheet feeder.
