Tally Genicom Matrix Printer manual Special Feature, Sub

Special Feature

If you not get the required control codes for Barcode of ASCII code table columns 0 and 1 out of your computer you can use in addition to these Barcode control codes a set of MTPL sequences to generate these control codes by printable ASCII characters. By this measure the Barcode programs will remain fully compatible in spite of the additional MTPL sequences.

Following control codes in Barcode strings can be substituted by the appropriate ANSI se- quences:

	ANSI Sequence
Control Code	(CSI = Hex 9B or	Example (Hex)
	Hex 1B 5B or
	ESC[ )
SUB	CSI 26 Space s	1B 5B 32 36 20 73
EM	CSI 25 Space s	1B 5B 32 35 20 73
DC4	CSI 20 Space s	1B 5B 32 30 20 73
DLE	CSI 16 Space s	1B 5B 31 36 20 73
SI	CSI 15 Space s	1B 5B 31 35 20 73

ANSI sequences with not matching parameters will be ignored.

These feature is not available with all printers with MTPL emulation.

Special firmware is possibly necessary. Please ask your dealer or representative!

Introduction 5