Introduction

This User’s Manual describes all barcode and LCP sequences and control codes, regard- less of your printer’s special barcode and LCP implementation (LCP = Large Character Printing).

Be sure to observe the notes in the operator’s manual regarding the special barcode/LCP Types implemented in your printer and which of the sequences described here are not available as a result.

Select the Barcode Mode as described in the operator’s manual. Selecting this emulation mode automatically selects the corresponding character set.

To print barcode or LCP characters, the following steps must be carried out in most cases:

Activate barcode

Activate secured/unsecured mode

(see section "Secured/Unsecured Mode")

Transfer barcode and/or LCP header

(see sections "Barcode Header" and "LCP Header")

Calculate check number

(barcode only, see section "Calculate Check Number")

Transfer barcode and/or LCP data

(see sections "Barcode Typees" and "LCP Header")

Deactivate barcode (if necessary)

The following commands are used to print barcode and LCP characters:

SUB

Start Character Barcode header

DLE

Start Character LCP header

EM

Stop Character Barcode and LCP header

DC4

Barcode brackets (start and end characters for barcode data)

SI

LCP brackets (start and end characters for LCP data)

ESC P ... ESC \

Settings for Barcode and LCP

2Introduction

Page 357
Image 357
Tally Genicom Matrix Printer manual Sub, Dle