Commands

Description

 

ESC c

RESET TO INITIAL STATE

 

Recalls the user format presently assigned to the current paper path.

 

Dec 27 99

Hex 1B 63

ESC [(p1)t

ENABLE/DISABLE OVERSIZED/EXPANDED/BAR CODE MODES

 

p1 Effect

Page

ESC [(p1); (p2)<SP>B

0

reset special modes

 

1

select oversized printing

4-2

2

select expanded printing

4-2

3

select bar code

3-6

Oversized printing and bar codes are explained in separate chapters. When expanded printing is selected, the current font is expanded horizontally and vertically in 100% increments according to expansion factors specified by ESC [(p1);(p2)<SP>B (see page 11). The range of expansion is 1x through 8x.

Example: select expanded printing

Dec 27 91 50 116 Hex 1B 5B 32 74

GRAPHIC SIZE MODIFICATION

Sets the size of expanded and oversized characters. The effect of this command on oversized is explained in a separate chapter.

When expanded print is selected, the argument units for parameters p1 and p2 are percentages of the vertical and horizontal dimensions of the current font. Parameter p1 controls the vertical expansion and p2 controls the horizontal expansion. The argument limits for expanded print are 800;800 (8x the parent font size).

Oversized enables much larger expansions. Parameters are rounded down to the nearest 100.

Note: This printer goes into expanded mode immediately on receiving this command. Any text between this sequence and a countermanding ESC [(p1)t sequence (see page 11) is printed according to the specified expansion.

If height and width are different values, the height will be set the same as the width.

ESC [(p1);

SET MODE (ANSI)

 

...(pn)h

p

Effect

 

 

20 auto CR on LF

 

 

Dec 27 91 50 48 104

Hex 1B 5B 32 30 68

7265 Programmer’s Manual

11

Copyright © 2004 TallyGenicom

Chapter 2 ANSI

Page 15
Image 15
Tally Genicom Matrix Printer manual Reset to Initial State, ENABLE/DISABLE OVERSIZED/EXPANDED/BAR Code Modes