Commands Description
DEL DELETE
DEL is a printable character, or is a valid graphics data byte if received in dot graphics mode.
ESC [(p1); (p2)<SP>~
Dec 127 | Hex 7F |
SELECT EMULATION
If p2 is 0, which is the default, then the current settings in the printer remain in effect through the emulation change to the extent that selected features are supported in the target emulation. This affects such things as, font selection, character pitch, margins, tabs, and so forth. If p2 is 1, then the status of such parameters reverts to defaults dependent on the selected emulation.
p1 selects
0GENICOM ANSI
1Tally ANSI
Reserved | |
22 | Epson FX286e |
p2 | selects |
full reset |
Example: Select Epson emulation with full reset:
Dec 27 91 50 50 59 49 32 126 | Hex 1B 5B 32 32 3B 31 20 7E |
ESC [(p1)p SELECT PAPER PATH |
|
p1 selects
08 unload current path
10unload current path and load tractor 2
12unload current path and load tractor 1
Forms in the current path should be torn off before changing paper paths. If you send a command to change paper paths and there is more paper downstream of the print head than 1/2 times the current form length or six inches, whichever is greater, then the printer returns paper to the position that was current before the command was received, and a fault condition is set.
If you send a command to change paper paths and the target path is the current path, then the printer executes a form feed. If you load tractor 2 when tractor 2 is not installed, the command will be ignored.
Example: Unload tractor 1 and load tractor 2:
Dec 27 91 49 48 112 | Hex 1B 5B 31 30 70 |
7265 Programmer’s Manual | 10 |
Copyright © 2004 TallyGenicom | Chapter 2 ANSI |
