Primera Technology RX900 user manual SET the Output Mode

TOC INDEX

Continuous. (Sensor off) If you have continuous stock with no die-cut, reflective mark or holes, set the sensor type to Continuous. This will turn off the stock sensor. It this mode there is no way to set the print starting position. The printer will simply start printing the first label and print each subse- quent label immediately after that previous one. To produce a gap between prints simply add the desired amount of white space to the end of the label being printed.

Important Note: You must also set the Stock Sensor Position (Section 2C) so that the sensor is sensing the correct point on the label stock.

E: SET THE OUTPUT MODE

Toggle the Output Mode to set whether or not the last label printed will be presented or left inside the printer. To adjust the output mode, open the PTStatus program. PTStatus auto- matically installs with your printer driver and can be accessed through the printer driver or as program that is accessible in the same manner as all other programs.

1.Connect the printer via USB and turn on the power. The Output Mode Setting is stored on printer main board so you will not be able to access it unless the printer is turned on and properly communicating with the computer.

2.Go to Start - Programs - Primera Technology - PTStatus.

3.Click on the Alignment Tab (3rd tab from top).

4.Click on the Output Mode button.

5.Select the Output Mode by clicking on the corresponding graphic.

Label Stock 15