TOC | INDEX |
C. OTHER FUNCTIONS
Batch Reading Test. (Optional) After printing and encoding labels you may run a Batch reading test to verify that each label was encoded successfully. Simply load the printed roll, open the status monitor and choose Batch Reading Test on the RFID tab.
Move to next tag. Before reading, writing or calibrating, select Move to next tag to instruct the printer to feed the label stock to the next tag/label.
Print and encode. Use this interface to test printing and encoding. Be sure to set your label size via the printer driver settings accessible in printer preferences as described in Section 5F.
(lower right on RFID tab). Click this to access and advanced encoding interface. This interface will allow
you to communicate directly with the RFID module via text commands. Do not use this interface unless directed to do so by tech support.
Advanced Options. Access advanced options by clicking the icon on the top right side of the status monitor. Click the options button. There are
several options available. Below are the options that concern RFID encoding.
Print 'XXXX' on RFID Failure. By default a series of XXXXs will automatically be printed on the label to indicate that it was not encoded properly. If you disable this option nothing will be print- ed on an encoding failure.
Unpresent Time. This is the time between the finish of the print and when the printer moves the stock back into position for the
next encoding/printing. The purpose of this setting is to allow a specific amount of time to remove the label after a one off print.
Unpresent Position. This is the position the label stock moves to after the unpresent time has elapsed. This should be set to RFID Tag when printing and encoding RFID labels.
