TOC | INDEX |
Note: Write success is less likely as you move the marker away from the center of the label.
Set Marker
approximately 1/8" (3mm) left or right from center chip of antenna.
Important Note: The remaining steps are optional and only necessary if encoding problems are present. If you are loading a new roll with the exact same specifications as the last roll, none of these steps will be necessary.
3.Open the PTStatus Monitor to test write to the RFID chip and verify the correct position of the Reader/Writer. Go Start - All Programs - Primera Technology - PTStatus.
Click on the RFID tab.
4.Click "Calibrate". PTStatus will automatically calibrate optimal position and Antenna Power. This process may take up to three minutes. During this time the stock position and antenna power are automatically adjusted. After this, ten write and ten verification reads are performed on the same label.
5.Writing Test. If further testing is desired or if the automatic calibration failed you can perform a writing test. Select the Writing Test button to start.
The RX900 will write to the same label continuously until "Stop Test" is selected. The results of each test will be dis- played in PTStatus. During this time you can adjust the Slide Bar if necessary until you receive a successful test. If the test is not successful you will see a "Write Failed" error.
