Printek FormsPro 4000se Series Character Attributes, character width, Select Emphasized Mode

IBM Proprinter Emulation

m3	hex	character height and line spacing
0	00	no change

101 line feeds unchanged, single-high characters

202 line feeds unchanged, double-high characters

1610 single line feeds, character height unchanged

1711 single line feeds, single-high characters

1812 single line feeds, double-high characters

3220 double line feeds, character height unchanged

3321 double line feeds, single-high characters

3422 double line feeds, double-high characters

m4 hex character width

101 single-wide characters

202 double-wide characters

Example: The following escape sequence will select double-wide and double-high mode, with double line feeds.

Escape Sequence:	ESC	[	@	4	0	0	0	34	2
Hexadecimal:	1B	5B	40	04	00	00	00	22	02
Select Subscript or Superscript Mode									ESC S n

Selects subscript mode for n=1, or superscript mode for n=0. This will print characters about half the normal height, in the bottom or top half of the normal character cell.

Example: The following escape sequence will select superscript mode.

Escape Sequence:	ESC	S	0
Hexadecimal:	1B	53	30
Cancel Subscript and Superscript Mode			ESC T
Cancels subscript and superscript mode.
Escape Sequence:	ESC	T
Hexadecimal:	1B	54

Character Attributes

Select Emphasized Mode ESC E

Selects emphasized mode. This makes characters bolder by printing an extra dot to the right of each dot normally found in the character matrix. This will cut the print speed in half, but will not require an additional pass of the print head. Overrides the “Impact Force” value in the forms menu.

Escape Sequence:	ESC	E
Hexadecimal:	1B	45

49