|
| Genicom 3840 and 3410 ANSI Emulation |
Set Vetical Tab Stop |
| VTS |
If |
| |
Control Code: | VTS |
|
Hexadecimal: | 8A |
|
Set Vetical Tabs At Specified Positions | ESC [(p1);(p2)..(p12)v |
Sets vertical tabs at positions p1, p2, p3, etc. Up to 12 stops can be set at one time. Tab stops are measured in decipoints from the top print reference.
Example: Set tab stops at 4 and 7 inches.
Escape Sequence: | ESC | [ | 2 | 8 | 8 | 0 | ; | 5 | 0 | 4 | 0 | v |
Hexidemical: | 1B | 5B | 32 | 38 | 38 | 30 | 3B | 35 | 30 | 34 | 30 | 76 |
Forms Setup
Forms Setup | ESC [(p1);(p2);(p3)r |
Sets top of form and sets form length, as well as top and bottom margins, in decipoints. Parameter p1 is form length, p2 is the top margin, and p3 sets the length of white space between the baseline of the last allowed line and the end of the form. Any parameter not specified is assigned its default value. Maximum form length is 15840 decipoints (22 inches).
Default Values
p1 | 7920 decipoints | |
p2 | 0 decipoints | |
p3 | 0 decipoints |
Example:
Set
Escape Sequence: | ESC | [ | 5 | 7 6 | 0 | ; 7 2 | 0 ; | 7 | 2 | 0 | r |
Hexidemical: | 1B | 5B | 35 | 37 36 | 30 | 3B 37 32 | 30 3B | 37 | 32 | 30 | 72 |
Margin Setup |
|
|
|
|
|
|
|
|
| ESC [(p1);(p2)s |
Sets the left and right margin in decipoints; p1 is the left margin and p2 is the right. Distances are measured from the left print reference. This command takes effect following the next line terminator (you can’t set margins for the current line).
Example: Set the left margin at 0.4 inch and right margin at 6.9 inches, making a 6.5 inch print line.
Escape Sequence: | ESC [ | 2 8 8 ; 4 9 6 8 s |
118