Printek FormsPro 4000se Series Paper Shear, ANSI Bar Codes, Differences from Genicom 3840 and

Genicom 3840 and 3410 ANSI Emulation

Paper Shear

Paper Shear ESC [(p1);(p2);<SP>{

Parameter p1 = 1 selects the paper shear.

Parameter p2 = 1 executes a cutting sequence: If the vertical position is not at top-of-form, then a form feed is executed. Paper is advanced to the shear position and cut. The shear position should be set from the control panel so that paper is cut precisely at the perforation.

Escape Sequence:	ESC	[	1	;	1	SP	{
Hexadecimal:	1B	5B	31	3B	31	20	7B

Printek Genicom ANSI Emulation And Genicom 3840 & 3410 ANSI Mode Differences

The following functions in the Printek FP4000se, FM8000se and PM850 series printers Genicom ANSI Emulation have slightly different behavior than the Genicom 3840 or 3410 ANSI mode. In most cases, these differences will not affect the direct drop in replacement by the previously mentioned Printek printers.

ANSI Bar Codes

ANSI Bar Codes ESC [(p1);(p2);…(p12)}

Set Bar Code Parameters

Programs all barcode parameters. Barcode Parameters are stored in non-volatile memory, and all 12 parameters should be programmed once to ensure the desired results. Factory default is for Code 3 of 9.

Differences from Genicom 3840 and 3410:

p1 - Bar Code Style

This printer supports the following styles:

p1 Style

0Interleaved 2 of 5

4Code 3 of 9

13UPC-A

16Code 128 (subsets A, B and C)

p12 - Human Readable Font

Only the special barcode font is supported.

121