Genicom 3840 and 3410 ANSI Emulation
Software Options That Affect Barcodes
Software Options are selected under the FM8000se's front panel Setup feature. These settings are non- volatile. One of these options affects barcodes:
OPTIONS MENU Item | Description |
Top of Barcode | On / Off |
When enabled, the vertical position on exiting bar code mode places the text baseline for subsequent printing so the top of the next character printed will align with the top of the barcode. When disabled, the baseline for subsequent printing is 0.1 inch below the bottom of the bar code.
Barcode Options
Barcode Options | ESC ]6;4;(p3);(p4)ESC \ |
Set Options
This command enables
Differences from Genicom 3840:
Only these options are supported in this printer:
p4 = 25 (backup to top of oversized character)
p4 = 26 (backup to top of barcode)
All other equivalent options are available through the FP4000se, FM8000se and PM850 series front panel Setup Mode.
Ignore Character
This feature is accessible through the OPTIONS MENU from the FP4000se, FM8000se and PM850 series printers front panel Setup Mode. This allows a single 8 bit character to be discarded as it is received. This is useful when the host application is sending an unwanted control character, for example.
To use this feature, refer to the printers Operation Manual and go to chapter Printer Configuration. Refer to the OPTIONS MENU and turn “On” the Ignore Character feature.
Note: This feature should not be left active unless needed.
122