Calibrating The Printer
To avoid this problem, increase the Threshold Range value to 60% in the CALIBRATE CTRL menu (the default is 50%), then run an Auto Calibrate again (page 30).
NOTE: Any changes to Threshold Range will not take effect until you run an Auto Calibrate again.
This will raise the Gap/Mark threshold high enough so that the printer will not falsely use the antenna or noise as the gap
255 |
191 |
127 |
Paper Out(075) |
063 |
Gap/Mark(040) |
000 |
Detected Amplitude | Detected Amplitude |
of the Antenna | of the Gap |
36
