Hor Image Shift, Orientation | Printronix SL5000r specs

QUICK SETUP Menu Items

the image is not affected by this parameter. The allowable range is –1.00 inches to the current Label Length value setting, up to a maximum of 12.80 inches, in 0.01 inch increments.

The default value is 0.00 inches.

Hor Image Shift

This menu item specifies the amount to shift an image left (–) or right (+) for precise positioning on the label. The actual width of the image is not affected by this parameter. The allowable range is –1.00 to +1.00 inches in 0.01 inch increments.

The default value is 0.00 inches.

Orientation

Specifies the image orientation to be used when printing the label.

•Portrait. The default. Portrait refers to vertical page orientation, where the height of a page is greater than its width. The top edge of the image is parallel to the leading edge of the media. The following example is viewed from the front of the printer.

NOTE: Portrait orientation applies to PGL® and VGL emulations. This is regarded as Inverse Portrait using PPI/ZGL.

4 inches

FEED

.media the of edge leading the to parallel is image the of edge top The

6 inches

Leading Edge

43

Image 43

Printronix SL5000r manual Hor Image Shift, Orientation

Contents

Quick Setup Guide Page Page Definitions Software License Agreement Termination of License Agreement Canada Communication Notices Declaration Of Conformity CE Notice European Union Trademark Acknowledgements Taiwan Lithium Battery Warning Table of Contents Table of Contents Unpacking The Printer Unpacking And Installing The Printer Removing The Internal Packing Material Unpacking And Installing The Printer Installation Installation Control Panel Controls And IndicatorsPower Switch Controls And Indicators Liquid Crystal JOB Select Key Control Panel Keys Control Panel Down Key in Menu mode Menu Key Loading Media And Ribbon Loading Media And Ribbon Loading Roll Media Loading Roll Media Media Roll Media Hanger Guide Media Width Media Damper Loading Roll Media Lower Media Sensor Fixed Guide Media Width Notch Loading Ribbon Loading Ribbon Loading Media And Ribbon Left Pressure Block Printing AdjustmentsPrinthead Pressure Adjustment Printhead Pressure Block Adjustments Positioning The Media Sensors Printing Adjustments Feed Positioning The Media Sensors Running Auto Calibrate Calibrating The PrinterCalibrating The Printer Running Auto Calibrate Making a Media Profile Printout Making a Media Profile Printout Gap Sensing 255 191 127 Advanced Gap Sensing Paper Out075 Changing The Active IGP Emulation Configuring The Printer Quick Setup Menu Quick Setup Menu Cont. from previous Print Speed Quick Setup Menu ItemsPrint Mode Print Intensity Media Handling Quick Setup Menu Items Ver Image Shift Paper Feed ShiftLabel Length Label Width Orientation Hor Image Shift EdgetopTheof isimagethe thetoparallelleft theofedgemedia Quick Setup Menu Items Gap Sensing for Smart Labels Gap/Mark Sensor Auto Calibrate Validator Funct Save ConfigActive IGP Emul SMT Select Tool Power-Up ConfigSMT Status SMT Sel Toolset Auto Save Configuration Saving The ConfigurationSaving The Configuration Loading a Saved Configuration Selecting The Power-Up Configuration Printing a Configuration Printing a Configuration Run a Barcode Demo Test Exterior CleaningGeneral Cleaning Cleaning The Printhead, Platen Roller, Media Sensors Cleaning The Printhead, Platen Roller, And Media Sensors Platen Roller CleaningMedia Sensor Cleaning Media Damper Cleaning Cleaning Upper Media Sensor From Printhead Heating Elements Repacking The Printer Repacking The Printer Media Cover window side Straps not supplied Contact Information Contact InformationPrintronix Customer Support Center Printronix Supplies Department Corporate Offices For More InformationCorporate Offices Page Page 178423-001