Chapter 2 QUICK SETUP Menu
48
•Disabled.The printer will not command the validator to begin
scanning and no errors will be reported. The counters will not
be incremented while the validator is disabled.
NOTE: If you save a configurationwith the validator enabled,
power down and power up, and the validator is not
connected or not functioning, the error message “Validator
not communicating”will display briefly. The Validat or menu
will not display.
If the validator is installed, the default is Enable.
Save Config.
Allows you to save up to eight unique configurations to m eet
different print job requirements. This eliminates the need to change
the parameter settings for each new job. The configurations are
stored in memory and will not be lost if you turn off th e printer. The
default is 1.
Power-Up Config.
You can specify one of the eight configurations as th e power-up
configuration. The default is Factory.
SMT: Status
This menu appears only if the RFID UHF encoder is installed. See
“SoftwareMigration Tools (SMT)”on page 63.
•Disabled.The printer will disable the use of the Software
Migration Tools.
•Enabled. The printer will enable the use of the Software
Migration Tools.
SMT: Sel Toolset
This menu appears only if the RFID UHF encoder is installed. See
“SoftwareMigration Tools (SMT)”on page 63.
•Toolset [1].SMTsforPGL
®emulation.
•Toolset [2]. SMTs for PPI1 emulation.
•Toolset [3] and Toolset [4]. Reserved for internal use and
future design.