General Features

The following section contains the general features that are common to all interfaces. These features allow modification of the scanner’s behavior to accommodate user preferences.

•Green LED Lamp Idle State

•Beeper Settings

•Marker Beam Settings

•AutoSense® Stand Mode

•Low Power Mode

•Low Power Shut-down Delay

•Half-Angle

•Multiple Read Mode

Programming the General Features

Green LED

Lamp Idle

State

Use the special bar codes on the following pages to configure the features common to all interfaces.

When the scanner is idle, its green LED lamp can be programmed to indicate this in one of two ways:

•LED lamp is OFF when the scanner is idle.

•LED lamp is ON when the scanner is idle.

SET -------------------------------------------

LED OFF---------

LED ON---------

END ------------------------------------------

130

PowerScan™ Scanner