It is recommended that programming ses-

 

sions be limited to one feature at a time.

 

Should you make a mistake in the program-

 

ming sequence, it can be difficult to discover

 

where an error has been made if several fea-

NOTE

tures are programmed at once. Additionally, it

can be confusing to determine which features

 

may or may not have been successfully set

 

following such a session.

3.Scan the END label at the bottom of the page to save any new settings and exit Programming Mode. The scanner will sound a beep and reset upon exiting Programming Mode, and the green LED will return to its usual state (on steady or off).

The scanner will not exit Programming Mode unless the END bar code is scanned or power is disconnected. Disconnecting power during Programming Mode, before scanning the END label, will cause all new settings to be ignored. On power-up, the scanner will return to previous settings.

4.Maintain a good record of all changes made to ensure that you know if the original factory settings have been changed.

8

PowerScan™ Scanner