Wand

Emulation Pre/

Post-Noise

Settings

The number of noise transitions generated prior to or following label transitions are independently configurable options. To set either pre- or post-noise transitions, enter Programming Mode by scanning the SET bar code, then follow these steps:

1.Scan Don’t Transmit Pre-Noise or Don’t Transmit Post-Noise, followed by the END bar code to disable noise transitions, or...

2.Scan the Set Pre- or Post -Noise Transitions bar code followed

by the digits from Appendix C: Keypad that represent the desired number of noise transitions. Select from one to twenty1 noise transitions for either pre- or post-noise. Complete the programming sequence by scanning the END bar code.

NOTE

Pre-Noise

Settings

Settings for this feature have been enhanced since the product was originally released, adding the option to select a specific quantity of noise transitions. If your scanner has a date code of February, 2001 or before, pre-noise/ post-noise transitions are enabled by following Step 2 above, EXCEPT the single digit selected from Appendix C: Keypad MUST be one (1).

This will either set the pre-noise transitions to one or the post-noise transitions to three depending on which feature is being pro- grammed. The feature is disabled in the same manner as Step 1 above.

SET -------------------------------------------

Pre-Noise

Don’t Transmit

Pre-Noise---------

1.Scanners with a date code of February of 2001 or before MUST select the digits zero-one (01). See the note on this page for details.

18

PowerScan™ Scanner