Where To Go From Here
Programming is easy and straightforward if you follow these steps:
| If you are changing some interface types (for | |
| example; if you are moving the scanner from a | |
| Universal Keyboard Wedge to an | |
| you must first change the hardware. Replace | |
| the scanner’s interface board (if required) and | |
NOTE | connect the scanner using the new interface | |
cable BEFORE performing any programming | ||
| ||
| changes. |
1.If you are changing the scanner’s interface type, follow the instructions in the section titled, Changing Interfaces on page 2 before proceeding.
2.Scan any feature bar codes that are unique to the interface you are currently programming. These interface specific program- ming bar codes immediately follow each interface selection label.
3.Turn to Symbologies Supported on page 60 if you are going to change any bar code symbologies or modify any symbology- related features.
4.Turn to General Features on page 130 if you wish to change or modify any of the scanner’s other features.
Once the necessary changes have been made, and you have scanned the END bar code, you are ready to scan.
Programming Guide | 13 |