Q-Logic 3100, 3000 manual 3. Local Area Connection Properties Dialog Box

7–Windows Server 2003, 2008, and 2008 R2 Driver Configuration QLogic Adapter Configuration

If there is a red X next to QLogic adapter icon, the link is down. In this case, do the following:

a.Verify that the card is seated properly in the PCI slot.

b.Make sure that the network cable is connected properly at both ends.

c.Make sure that the cable is good.

d.Assign an IP address to the interface if you have not already.

e.Verify that the SFP+ module is installed correctly (QLE3142).

See Section 11 for more information.

2.To check the status of the connection, right-click the adapter icon in the Network Connections window, and then select Properties.

The Local Area Connection Properties dialog box opens (Figure 7-3).

Figure 7-3. Local Area Connection Properties Dialog Box

3.Assign an IP address manually by selecting the Internet Protocol (TCP/IP) entry, and then clicking the Properties button.

7-10 NE0154601-00 B