Quadra-Fire VOYAGEUR-MBK, VOYAGEUR-PMH D. Blower Replacement, VOYAGEUR Wood Insert, Figure

R

VOYAGEUR Wood Insert

D. Blower Replacement

1.The grille on the blower access assembly is hinged. Swing the grille downward to expose the 2 screws.

Figure 23.1.

2.Remove the 2 screws from the blower access assembly and slide assembly away from the appliance.

3.Disconnect the wires from the blower.

4.Remove the 2 screws from the hold down bracket and pull the blower and bracket forward.

5.Remove the blower from the hold down bracket.

6.Remove the protection guards from each end of the blower.

7.Re-install in reverse order. Be certain that the hold down bracket’s screws are completely seated in the grom- ments. Insert the locating tab in the hold down bracket into the placement slot.

CAUTION

Shock Risk.

•Do NOT remove grounding prong from plug.

•Plug directly into properly grounded 3 prong receptacle.

•Route cord away from appliance.

•Do NOT route cord under or in front of appliance.

WARNING

Fire Risk.

Do NOT allow hot coals or embers to overfl ow ash lip

•May melt protective wire coating on fan power cord causing electrical short, fi re or injury

CAUTION! Unplug appliance from power source before replacing any components.

Placement Slot

Blower Access

Assembly

Grille hinges	Hold Down
downward
	Bracket

		Remove Screws and
Remove Screws &		Remove Both
Pull Access Assembly	Remove Screws from Hold	Protection Guards at
away from Insert		Each End
	Down Bracket and Pull

Forward

Figure 23.1

November 22, 2011 7063-173D Page 23