R
VOYAGEUR Wood Insert
G. Standard Surround & Cast Trim Kit
Standard Size:
Large Size: 48 in. W x 34 in. H
Included in Surround Kit: (2) side pieces, left and right; (1) l top piece; (1) fastener package.
Included in Cast Trim Kit: (2) cast trim legs, left and right;
(1)cast trim header; (2) cast trim footers, left and right; (1) fastener package.
Tools Needed: Powered 4 to 6 inches long Phillips head screw driver; pliers
1.Remove contents from box being careful not to scratch or damage the cast trim pieces.
2. Lay surround face down on a protected surface to prevent scratching.
3.Using a 4 to 6 inches long Phillips head screw driver attach the side surrounds to the top surround using (2) #8 sheet metal screws on each side provided with the kit
7.Place the cast footers under the metal sides aligning the top and bottom holes in the cast footers and metal sides.
8.The 9 mounting clips are shipped in one long strip. Hand break apart or use pliers.
9.Each clip has a clearance notch to allow room for the cast on the insert. Place the clip so the notch is facing the outer edges of the surrounds. Figure 43.3.
10.It is best to install all of the
11.Slide surround and trim over the top of the insert into place matching the mounting tabs on the metal sides with the slots on the insert. Figure 43.4.
12.Align the 2 screws in the top metal surround piece to the 2 alignment holes on the appliance top. Secure in place.
Figure 43.4.
4. Place the peel and stick round felt vibration insulation pads on the front side in each corner of the top metal piece and on the back side in each corner of the top cast piece. Figure 43.1.
5.Place the corresponding cast trim pieces (2 cast trim sides and 1 cast trim header) underneath the panel set, also face down. Align the holes in the metal pieces with the 5 bosses on the top cast piece and 2 bosses on each side piece.
6.Secure the magnet to the bracket and attach the magnet and bracket to each metal side piece at the bottom. The magnet is facing the front. Figure 43.2.
(4) Felt Vibration Insulation Pads |
Secure |
Surrounds to |
Cast Trim Kit |
BACK |
OF |
SIDE |
PIECE |
Magnet Attached - Faces Front |
Figure 43.2
CLEARANCE NOTCH
Figure 43.3
Attach Magnet |
before installing |
Cast Footers |
Cast Footers, |
Left & Right |
Magnet Installed |
Figure 43.1
Match Mounting |
Tabs to Slots on |
the appliance |
Figure 43.4
November 22, 2011 | Page 43 |
