R
VOYAGEUR Wood Insert
F. Burning Process
In recent years there has been an increasing concern about air quality. Much of the blame for poor air quality has been placed on the burning of wood for home heating.
In order to improve the situation, we at
These wood appliances must be properly operated in order to ensure that they perform the way they are designed to perform.
2. Second Stage
In the secondary stage wood gives off fl ammable gases which burn above the fuel with bright fl ames.
During this stage of burning:
•The fl ames must be maintained and not allowed to go out to ensure the cleanest possible fi re.
•If the fl ames tend to go out, it is set too low for your burn- ing conditions.
The air control located at the upper right hand corner is used to adjust for burn rates. This is called the Burn Rate Air Control.
Figure 10.1 on page 10.
3. Final Stage
NOTICE: Improper operation can turn any wood appli- ance into a smoldering environmental hazard.
1. Kindling or First Stage
It helps to know a little about the actual process of burning in order to understand what goes on inside the appliance. The fi rst stage of burning is called the kindling stage.
In this stage:
•Wood is heated to a temperature high enough to evapo- rate the moisture present in all wood.
•Wood will reach the boiling point of water (212°F) and will not get any hotter until the water is evaporated.
This process takes heat from the coals and tends to cool the appliance.
Fire requires three things to burn:
•Fuel
•Air
•Heat
If heat is robbed from the appliance during the drying stage, the new load of wood has reduced the chances for a good clean burn.
It is always best to burn dry, seasoned fi rewood. When the wood isn’t dry, you must open the air controls and burn at a high burn setting for a longer time to start it burning.
The heat generated from the fi re should be warming your home and establishing the fl ue draft, not evaporating the moisture out of wet, unseasoned wood, resulting in wasted heat.
The fi nal stage of burning is the charcoal stage. This occurs when the fl ammable gases have been mostly burned and only charcoal remains. This is a naturally clean portion of the burn. The coals burn with hot blue fl ames.
•It is very important to reload your appliance while enough lively hot coals remain in order to provide the amount of heat needed to dry and rekindle the next load of wood.
•It is best to open the Burn Rate Air and
•Open door slowly so that ash or smoke does not exit ap- pliance through opening.
•Break up any large chunks and distribute the coals so that the new wood is laid on hot coals.
Air quality is important to all of us, and if we choose to use wood to heat our homes we should do so responsibly.
We need to learn to burn in the cleanest way possible al- lowing us to continue using our wood appliances for many years to come.
November 22, 2011 | Page 9 |
