Radio Shack PRO-97 manual Programming Motorola trunking systems UHF-Lo

Beyond the Basics

6.To enter additional trunking frequencies as subsequent channels in the same bank, press PGM or e to access the next open channel then enter the frequencies. (See “Storing Known Frequencies into Channels”).

7. Press SCAN to start scanning.

Notes

If you enter a frequency that has already been entered, the scanner sounds an error tone and displays Dupl. Freq. and the channel number that has been duplicated. If the dual entry is an error press CL and enter the correct frequency. If the dual entry is intentional press ENT to accept.

You may replace any frequency by selecting the bank and channel, pressing PGM and entering the new frequency.

If you make an error in the entry process, press CL as often as needed to erase the incorrect data.

programming Motorola trunking systems (UHF-Lo)

You can program the scanner to receive transmissions in the UHF-Lo band (406-512 MHz) of the Motorola trunking system. You can receive these transmissions by checking the trunking system’s control channel. You must program the system’s base frequency and offset frequency to do this.

69