RCA CC616 manual Install Lithium Cell, Remote Sensor

Remote Control

Install Lithium Cell

The remote’s lithium cell is packed separately. Install it as follows:

Back of

Remote Control

Holder

Insert Pencil Here

Lithium Cell

Cautions: Lithium cell battery. Replace only with 3-volt lithium cell – such as CR2025. Use of other cell presents a risk of fire or explosion. Must be disposed of properly. Never handle punctured or leaking cell. May cause burns or personal injury.

Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult a physician immediately for emergency treatment.

The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.

1.Turn remote over, insert a pencil or paper clip in small hole and remove battery holder.

2.Insert battery in battery holder so positive (+) terminal faces up.

3.Replace battery holder in remote until it clicks into place.

Notes: Never place anything heavy on top of the remote control or lay it upside-down.

Replace battery when camcorder fails to respond to remote.

Remove battery from remote if it will not be used for a month or more. This will prevent possible damage from battery leakage.

If leakage occurs, wipe up liquid inside compartment and replace battery.

Remote Sensor

The remote operates the camcorder by infrared light, so it is protected from electrical and sound interference. However, the remote must be aimed directly at the camcorder’s remote sensor. There cannot be any obstructions between them.

Remote Control Sensor

	ZOOM
	PLAY	START/STOP
	STOP	SELF
	TIME	INT
	REW	TIME.
	REC
	TIME LAPSE
INSERT	ANIM
	PAUSE.
	FF
	A.
	DUB

F1

MODE

SELECT

SCENE

F2

M

TO

U

A

H S U P

Note: The camcorder may not respond to the remote if its sensor is exposed to direct sunlight or strong artificial light.

18