RCA CC616 manual Playback on a TV Without Audio/Video Inputs, Installation

Playback

Playback on a TV Without Audio/Video Inputs

To connect your camcorder to a TV without audio/video inputs, you will need an optional 1CVA147C RF output adapter and an optional coaxial RF cable, such as AH065G or AH066G shown on page 66. If your TV has AUDIO and VIDEO IN jacks (or is connected to a VCR), refer to pages 60-61.

VHF Antenna

	Optional Coaxial
1	RF Cable
	(such as AH065G or AH066G)
OR
	Back of TV
	2	VHF			VCR
					POWER
	OR
					OFF
					CAMERA
	Optional			AUDIO
				RF
	Transformer				OUT
				DC
	(Such as AH011)	VHF		VIDEO
			3	AUDIO, RF DC
	2			OUT, VIDEO Jacks
OR
	OUT TO TV Connector
Optional				RF Output
	VCR/TV Switch
Transformer				Adapter's Plug

(Such as 193983)
IN FROM ANT
Connector	CH3/CH4 Switch	Optional RF Output Adapter
		(1CVA147C)

DATE/TIME/ •30•40

TRA R/M

RCH REW

Installation

1Disconnect the VHF antenna from your TV. Connect the antenna to the IN FROM ANT connector on the RF output adapter if you are going to leave the adapter connected to the TV.

Note: If your VHF antenna is the flat twin-lead type attached by two screws, you will also need an optional 300/75 ohm transformer, such as 193983 shown on page 66.

2Attach one end of the optional coaxial RF cable to the OUT TO TV connector on the adapter, and attach the other end to the VHF input on your TV as shown.

Note: If your TV has 300 ohm screw terminals, you will need a 75/300 ohm transformer, such as AH011, shown on page 66.

3Attach the RF output adapter’s plug to the AUDIO, RF DC OUT, and VIDEO jacks located under the small cover on the back of the camcorder.

62