MAINTENANCE
MAINTENANCE
MAINTENANCE
INSTRUCTIONS
1)Always turn off the gas valve before cleaning. For relighting, refer to lighting instructions. Keep the burner and control compartment clean by brushing and vacuuming at least once a year. When cleaning the logs, use a soft clean paint brush as the logs are fragile and easily damaged.
2)Clean appliance and door with a damp cloth (never when unit is hot). Never use an abrasive cleaner. The glass should be cleaned with a gas fireplace glass cleaner.
The glass should be cleaned when it starts looking cloudy.
3)Make a periodic check of burner for proper position and condition. Visually check the flame of the burner periodically, making sure the flames are steady; not lifting or floating. If there is a problem, call a qualified service person.
4)The appliance and venting system must be inspected before use, and at least annually, by a qualified field service person, to ensure that the flow of combustion and ventilation air is not obstructed.
Note: Never operate the appliance without the glass properly secured in place.
5)Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
6)In the event this appliance has been serviced check that the
7)Verify operation after servicing.
2)Remove the Cap, and shine a flashlight down the Vent. Remove any bird nests, or other foreign material.
3)Check for evidences of excessive condensation, such as water droplets forming in the inner liner, and subsequently dripping out the joints, Continuous condensation can cause corrosion of caps, pipe, and fittings. It may be caused by having excessive lateral runs, too many elbows, and exterior portions of the system being exposed to cold weather.
4)Inspect joints, to verify that no pipe sections or fittings have been disturbed, and consequently loosened. Also check mechanical supports such as Wall Straps, or plumbers' tape for rigidity.
THERMOPILE /
THERMOCOUPLE
1)Remove the valve tray by following the procedures from "Valve Tray Replacement" section.
2)Disconnect thermocouple by loosening nut from the valve with a 9mm wrench. Disconnect thermopile by loosening 2 screws marked TP on the valve.
3)Remove 2 screws from the pilot assembly and pull up far enough to be able to loosen the thermocouple or thermopile with a 7/16" wrench. NOTE: the pilot line is very fragile, use caution when pulling it up.
4)Drop the thermocouple or thermopile down through the extrusion and pull it out of the unit.
5)Reinstall the new ones in reverse order.
DOOR GLASS
Your Regency® fireplace is supplied with high temperature
CAUTION & WARNINGS:
*Do not clean when the glass is hot.
*The use of substitute glass will void all product warranties.
*Care must be taken to avoid breakage of the glass.
*Do not strike or abuse the glass.
*Do not operate this fireplace without the glass front or with a cracked or broken glass front.
*Wear gloves when removing damaged or broken glass.
*Replacement of the glass panel(s) should be done by a licensed or qualified service per son.
GLASS REPLACEMENT
In the event that you break your glass by impact, purchase your replacement from an authorized Regency® dealer only.
Replacement glass is shipped already installed into the door frame.
CAUTION: Wear gloves when removing damaged or broken glass.
WARNING: Do not operate the appliance with the glass panels removed, cracked or broken. Replacement of the glass panels should be done by a licensed or qualified service person.
GENERAL VENT
MAINTENANCE
Conduct an inspection of the venting system
1)Check the Venting System for corrosion in areas that are exposed to the elements. These will appear as rust spots or streaks, and in extreme cases, holes. These components should be replaced immediately.
GLASS GASKET
If the glass gasket requires replacement use a tadpole glass gasket (Part #
38 | Regency® L676S Direct Vent Gas Fireplace |
