OPERATING INSTRUCTIONS
OPERATION
NOTE: The control knob is located on the right hand side of the fi rebox behind the right side exterior brick panel.
1)Push in gas control knob slightly and turn clockwise to “OFF”. Knob cannot be turned from“PILOT”to“OFF”unlessknobispushed in slightly. Do not force.
2)Wait fi ve (5) minutes to clear out any gas.
3)Turn knob on gas control counterclockwise to “PILOT”.
4)Push in control knob all the way and hold in until the pilot lights up. Continue to hold the control knob in for about 20 seconds after the pilot is lit. Release knob and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 1) to 4). If knob does not pop up when released, stop and immediately call your service technician or gas supplier. If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and call your service technician or gas supplier.
5)Turn gas control knob
6)Turn the unit on with the remote.
NOTE: When using the remote control refer to the FireWizard manual for instructions.
SHUTDOWN
PROCEDURE
1)Turn the
2)Turn the main gas control clockwise to the "OFF" position to turn off the pilot.
3)Turn off all electric power to appliance if service is to be performed.
NORMAL OPERATING
SOUNDS OF
GAS APPLIANCES
It is possible that you will hear some sounds from your gas appliance.This is perfectly normal due to the fact that there are various gauges and types of steel used within your appliance. Listed below are some examples.All are normal operatingsoundsandshouldnotbeconsidered as defects in your appliance.
Burner Tray:
The burner tray is positioned directly under the burner tube and logs and is made of a different gauge material from the rest of the fi rebox and body. Therefore, the varying thicknesses of steel will expand and contract at slightly different rates which can cause "ticking" and "cracking" sounds. You should also be aware that as there are temperature changes within the unit these sounds will likely
Pilot Flame:
While the pilot fl ame is on it can make a very slight "whisper" sound.
Gas Control Valve:
As the gas control valve turns ON and OFF, a dull clicking sound may be audible, this is normal operation of a gas regulator or valve.
Unit Body/Firebox:
Different types and thicknesses of steel will expand and contract at different rates resulting in some "cracking" and "ticking" sounds will be heard throughout the cycling process.
OPERATION DURING
POWER OUTAGE
Important:
If the unit is not used for a prolonged period of time, we recommend turning the
Also see "Lighting Plate Instructions" for details on how to turn off the pilot.
Manual Control Panel
3-way Switch
Rear Burner
Switch
Located on the left hand side of the fi rebox behind the exterior brick panel.
When in "Remote" position;
In the event of a power failure, if the
To operate unit during a power failure;
NOTE: Both burners when on will operate at the lowest fl ame setting. The BTU's for NG will be 32,000 and 27,000 for LP.
Front Burner Operation:
1)Remove the left side exterior brick panel to access to the Manual Control Panel.
2)To turn on the front burner, change the
Rear Burner Operation:
1)Remove the left side exterior brick panel to access to the Manual Control Panel.
2)To turn on the rear burner, change the Rear Burner Switch to the "On" position. Changing the switch to the "Off" postion will turn the rear burner off.
Note: The rear burner will only operate if the front burner is on.
When in "Manual" position;
In the event of a power failure, if the
Both burners when on will operate at the lowest
flame setting. The BTU's for NG will be 32,000 and 27,000 for LP.
When power resumes the unit will remain on at the lowest setting until reset using the remote control.
NOTE: When power is restored, reset the
40 | Regency® L900 Direct Vent Gas Fireplace |
