INSTALLATION
BRICK PANELS INSTALLATION
1)Unhook the 2 spring loaded hooks from the bottom of the flush door and lift the Flush Front off the unit.
2)Unwrap the brick pattern panels from the protective wrapping.
Note: The logs must not be in the unit.
a)Loosen the two screws from the bottom of the
baffle plate. Install the bottom clips onto the | b a f f l e |
plate (refer to Diagram 1). |
|
Bottom
Clips
Diagram 1
3)Insert the back brick panel first by carefully slipping it between the back wall of the firebox and the rear log bracket (refer to Diagram 2).
Diagram 2
5)Place the top bracket onto the front edge of the top panel (refer to Diagram 5).
Top Bracket
Diagram 5
6)Slide the top panel and bracket assembly carefully onto the baffle plate ensuring the panel is centered. Make sure the tabs of the top bracket fit into the baffle openings (refer to Diagrams 6 & 7). The back of the top brick panel sits on top of the bottom clips.
Tabs
Diagram 6
Diagram 7
4)Put the side panels in next. Tilt them in towards the middle of the firebox and put the bottom front corner in first. Be very careful not to scratch them on the firebox hardware. Place them flat up against the wall, they should fit snugly against the top of the firebox (refer to Diagrams 3 & 4).
NOTE: If the bottom brick panel must be removed: Remove the grate, then remove the Burner Tray. See instructions in manual.
IMPORTANT
Dangerous operating conditions may occur if the panels are broken.
Diagrams 3 & 4
24 | Regency P48 Zero Clearance Direct Vent Gas Fireplace |
