INSTALLATION
OPTION 1: | OPTION 2: | OPTION 3: |
REMOTE CONTROL | WALL SWITCH | WALL THERMOSTAT |
Can be used with Option 2 or 3 | Can be used with Option 1 or 3 |
but not both. | but not both. |
Can be used with Option 1 or 2 but not both.
Use the Regency Remote Control Kit approved for this unit. Use of other systems may void your warranty.
The remote control kit comes with a hand held transmitter, a receiver and a wall mounting plate.
1)Choose a convenient location on the wall to install the receiver and the receptacle box (protection from extreme heat is very im- portant). Run wires from the fireplace to that location. Use the Thermostat Wire Ta- ble.
2)Connect the two wires to the gas valve. See diagram.
CAUTION
Do not connect millivolt remote
control wires to a 120V wire.
1)Run the supplied 15' of wire through the back gas inlet opening. Be careful not to damage wire.
Note: We recommend a maximum of 15' of wire but if you wish to go with a longer run, use the Thermostat Wire Table.
2)Connect the wire to the supplied wall switch and install into the receptacle box.
CAUTION
Do not connect millivolt
wall switch wire to a 120V wire.
A wall thermostat may be installed if desired, connect the wires as per the wiring diagram on page 29. Use the table below to determine the maximum wire length.
Note: Preferable if the thermostat is in- stalled on an interior wall.
Regency offers an optional programmable ther- mostat but any
CAUTION
Do not connect millivolt
wall thermostat wires
to a 120V wire.
Thermostat Wire TableRecommended Maximum Lead Length
Thermostat
Wire Size | Max. Length |
|
14 GA. | 50 Ft. |
|
16 GA. | 32 Ft. |
|
18 GA. | 20 Ft. |
|
20 GA. | 12 Ft. |
|
22 GA. | 9 Ft. |
|
|
|
|
3)Install 3 AAA alkaline batteries in transmitter and 4 AA alkaline batteries in the receiver. Install the receiver and its cover in the wall. Switch the remote receiver to "remote" mode. The remote control is now ready for operation.
Regency P48 Zero Clearance Direct Vent Gas Fireplace | 31 |