INSTALLATION
LOG SET INSTALLATION
Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.
The gas log kit (Part #
a) | Center Cross Log | ||
b) | Right Side Cross Log | ||
c) | Front Left Side Log | ||
d) | Front Right Side Log | ||
e) | Left Side End Log | ||
f ) | Rear Log | ||
g) | Middle Right Side Log | ||
h) | Right Side End Log | ||
i) |
| Embers (Lava) | |
h) |
| Vermiculite | |
|
|
|
|
|
|
|
02-87
|
| |
| ||
|
The "02" reference numbers (i.e. 02-83) are molded
into the rear of each log.
1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.
2)Sprinkle the vermiculite all over the top of the base brick panel.
3)Line up the two holes on the underside of Log
02-88
4)Place Log
02-88
1st Grate Post | Tab | Pin |
|
5)Line up the two holes on the underside of Log
02-88
02-85
Pins
Pins
Regency P48 Zero Clearance Direct Vent Gas Fireplace | 25 |