
5. System Maintenance Reference
Engine Maintenance
5
Waste toner disposal
Test Pattern
Prints the test pattern.
Sets the machine operation at "waste toner full" of the refilled AIO.
[On or Off (Default)]
•With main motor rotation count feature, machine can be set to stop printing after print total exceeds a certain set value. If print count exceeds this value, then "Replace Print Cartridge" remains in display. Then a new AIO cartridge must be installed. This feature is a safety measure to prevent the used toner tank from becoming full (there is no toner overflow detection mechanism).
Curl Control mode
Adjust of Charge Bias
Corrects the face curl of paper.
0:OFF (28ppm)
1:Sets the engine speed at 14ppm after printing 1 minute.
2:Sets the engine speed at 14ppm.
3 to 255: not available [0 to 255 / 0 / 1 /step]
Charge bias correction for dirty background
0:OFF (Default)
1:ON
2 to 255: not available [0 to 255 / 0 / 1 /step]
Scan Maintenance
Mono Compression | Sets the monochrome compression type for scanning. | ||
Setting | MH (Default)/ MR/ MMR | ||
|
|
|
|
96