2.Install the
3.Reassemble the three (3) brake shoes.
NOTE! Tighten shoulder bolts until they bottom out.
4.Reassemble rear centering assembly using new spacers and rear jaws supplied with the kit.
NOTE! Rear jaws must be oriented as shown for right hand threading. (Refer to Figure 27.)
5. Install top and front covers.
WARNING Do not operate machine with covers re-
moved.
NOTE! Once the machine is fitted with the new kit to thread plastic coated pipe, it is also capable of threading steel and galvanized pipe sizes 1/2″ – 2″. If smaller sizes than 1/2″ pipe are required, the original front and rear jaw assemblies must be in- stalled.
Step 1
Step 2
Step 3
Figure 26 – Removing Brake Shoes
Figure 27A – Jaw Orientation
Figure 27B – Jaw Orientation
Machine Storage
WARNING
Ridge Tool Company | 21 |