Figure 2 – Machine Dimensions
shown in the detail drawing. Use the four (4) 3/8″ - 16 x 21/2″ hex bolts to secure the legs to the
300 Compact 535 (Front)
1224 1233, 1822
(Front) (Front)535 Automatic
300Compact
1233, 1822 (Rear)
535
Automatic
535
1224
(Rear)
Detail Section
3/8″ - 16 x 21/2″ Bolt
4 Required
Figure 3 – Stand Assembly
NOTE! Insert axle into frame and secure it with a 1/2″ lock washer and nut.
4. Position stand stop bracket so that the end of the
bracket is held in place by the axle shaft. Slide a wheel onto the axle. Slide a flat washer over the axle and install a cotter pin to hold the wheels on the axle.
5.Mount machine to the stand using four (4) bolts that mount into each corner of the base.
CAUTION For proper balance and operation, RIDGID machines must be mounted through the appropriate holes in the rails (Figure 3).
Figure 4 – No. 1406 Folding Wheel Stand
6 | Ridge Tool Company |