Configuration
Connecting your radio to your computer network
1. Place your radio on a fl at surface and plug the mains lead into the mains socket located on the back of your radio ensuring that the plug is pushed fully into the socket.
2. If you wish to use a wired network connection, plug the Ethernet cable into the
3. Plug the other end of the mains lead into the wall socket and switch on the wall socket.
IMPORTANT: The mains plug is used as the means of connecting the radio to the mains supply. The mains socket used for the radio must remain accessible during normal use. In order to disconnect the radio from the mains completely, the mains plug should be removed from the mains socket outlet completely.
4. When you apply power, the display on the radio will light up and say: |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
'WELCOME' and 'STARTING' with a progress indicator. The fi rst time | 4,5 |
|
|
|
|
|
|
| |
that you use your radio (or after a Factory Reset) the display will show |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| |
'Setup wizard' and 'YES' will be highlighted on the screen. Press the |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Select button to start the setup wizard. You will then have a choice to |
|
|
|
|
|
|
|
|
|
set the clock to use the 12 or 24 hour format. |
|
|
|
|
|
|
|
|
|
You are recommended to run the setup wizard, but if you do not wish to then press the Menu Up or Down buttons until 'NO' is highlighted
on the display then press the Select button. The screen will ask if you4,5 4,5 wish to run the setup wizard again at the next start up. This will lead
to the main menu.
5.Press the Menu Up or Down buttons to highlight the desired clock format (either 12 or 24 hour) then press the Select button to enter your selection. A menu allowing you to specify the auto update option for the clock will appear on the display. The default of 'Update from Network' will be the best option for most users.
13
